Australian Monitor AMIS1202P
Description
The AMIS1202P is a dual channel 120W + 120W power amplifier designed to
deliver continuous full range performance in a compact and reliable package. The
AMIS1202P is two independent amplifiers in the one chassis making it the perfect
choice for multi-zone or multi-channel applications.
Inputs and Outputs
The AMIS1202P provides dual balanced XLR inputs (male and female) per
channel. These two inputs are wired in parallel enabling a line level 'split' to
be taken from the second input of each channel. 70 volt line and 4/8 ohm outputs
are available via the rear panel barrier strip.
Controls and Metering
A recessed input attenuation control for each channel is included on the rear
panel. These pots are accessible using a screwdriver. The AMIS1202P features a
signal-present LED per channel and power-on LED.
Protection
The AMIS1202P features 'slow start' and dual AC and DC fuse protection. Also
featured is automatic speaker protection. The AMIS1202P includes generous heat
sinking for reliable operation in even the most extreme conditions. Australian
Monitor Installation Series amplifiers feature a protection network that
provides greater stability and performance. Our amplifiers are recognised
worldwide for their reliability and this is due to the extensive levels of
current limiting which protect the amplifiers from both overload and overdrive
conditions.
AMIS1202P Specifications
- Power Output 120 Watts per channel
- Maximum Load 40 Ohms on 70 Volt line setting
- Frequency Response 60Hz - 23kHz (- 3dB)
- Total Harmonic Distortion 0.5% at 1kHz (1 Watt - full power)
- Signal To Noise Ratio -80dB at 70V; -80dB at 8 Ohms; -80dB at 4 Ohms
- Input Sensitivity 0.5 Volt RMS - 70 Volt line
- Input Impedance 10K Ohms
- Input Connection Active balanced input with male and female 3 pin XLR input/output sockets per channel.
- Outputs 70 Volt line and 4/8 Ohm via rear panel barrier strip. Line out to feed additional amplifiers from one of the paralleled XLR input sockets
- Controls Front panel power switch; Recessed rear panel input attenuator (per channel)
- Metering/Indicators Signal-present LED per channel
- Power Source 120VAC 60Hz 3 pin IEC connector; 24VDC
- Power Consumption 400 Watts (maximum)
- Protection Fuses for overload and short circuit protection, High temperature trip (disconnects load at 120¼C), DC Output Sensing (disconnects load if DC is present)
- Dimensions/Weight 3.5" H x 19" W x 11" D (Chassis dimensions only). 33.1lb
- Rack Mounting Standard
Architectural and Engineering Specifications
The power amplifier shall be a dual channel model capable of delivering 120
watts RMS per channel into 70 volt line and 4/8 ohm loads. The unit shall
feature a signal-present LED per channel. Speaker connection shall be via a rear
panel barrier strip. The amplifier shall have two balanced XLR inputs per
channel, one of which can be used to feed additional power amplifiers. The unit
shall also include fuse protection for overload and short circuit conditions.
The unit shall also feature generous heatsinking for reliable operation in
extreme conditions. The unit shall be of high quality suitable for continuous,
reliable performance. It shall have a frequency response of no less than 60Hz -
23kHz (- 3dB). Distortion shall not exceed 0.5% at 1kHz. The signal to noise
ratio shall be -80dB (on 100V setting) or better. The power amplifier shall be
packaged in a rugged 2 rack unit metal chassis suitable for desk or rack
mounting. The amplifier shall be an Australian Monitor Installation Series model
AMIS1202P.